Do you think that your washing machine is not working due to a fuse problem? No need to take drastic steps until everyone figured it out.
The fact is that many users confuse this detail with a surge protector. Indeed, the noise suppression filter acts as a kind of protective element that eliminates interference that can destabilize the operation of other devices and equipment.
In this article, we will tell you where the fuse is located in your washing machine.
Where to look for a fuse
The fuse is located on the control board.
Many foreign SMAs assembled in Europe are mandatory equipped with fuses; without them, washing machines are prohibited from being sold. But in models of Russian and Chinese production, the installation of such parts is calculated in isolated cases.
Therefore, your washing machine model may not have this part. We will tell you where to find the fuse below.
Part Search
In different models of washing machines, it can not only look different, but also be located in different places. If you don’t want to dig into your washing machine for a long time, find a wiring diagram that matches the brand. The location of the element will be clearly indicated there. If you cannot find the circuit, you will have to inspect those places where the fuse can supposedly be located. Check:
- Inside the plug from the wire to connect to the network.
- At the end of the network connection wire, which is located inside the case.
- On or near the electronic board.
For a thorough inspection, remove the top cover of the CM. Unscrew the two screws located at the back, push the cover in the opposite direction and remove. What the fuse looks like is shown in the photo below.
If you can’t find the part, it may not be in your model.
Causes and signs of breakage
If the washing machine stops working or is completely turned off, while the power is not supplied, the reason may be a faulty fuse. It could burn out as a result of a sharp power surge. Its principle of operation is to protect the control board during network outages. And since this is not uncommon in our power grids, equipment suffers first of all.
Is it worth repairing
Before making repairs, you need to think about how to check the fuse. You can check it with a multimeter tester. These parts may be different in appearance, but they are tested in the same way.
Do the work in the following order:
- Set your tester to resistance measurement mode.
- Disconnect the fuse from the element on which it is located.
- Press the probes of the tester to the contacts of the element.
- Look at the readings on the screen.
- A good element will show 0 ohms. If the tester does not show anything, then a malfunction has occurred.
A malfunction may indicate a short circuit in the electronic circuit of the washer: for example, the heating element has closed. Everything needs to be checked properly. Should I replace the fuse myself? It cannot be repaired, and manipulations with the electronic board can lead to an undesirable effect. Therefore, in this case, it is better to contact the master. A video on the topic will help you make an independent check: