What do Fagor washing machine error codes mean?

Error code Fault value Causes How to fix the situation d01 No water intake.

If the SM gives an error d 01, then the water intake system is clogged.

Also, the inlet valve or the main module may have failed.

1. Check for water in the plumbing.
2. Inspect the inlet hose, it may be kinked or clogged.
3. Check valve strainer for blockage.
4. Replace inlet valve if defective.
5. Test the managed module.

d02 Water drain error. What does error d 02 mean:

• there is a blockage in the drain system;
• SMA drain pump defective.

To reset an error:

1. Check drain pipe, filter and hose for blockage.
2. Examine the pump. Install a new pump if it breaks.

d03 No water heating.

• Heater failure.
• Failure of the heating element thermostat.
• Faulty control unit.

1. Inspection of the heating element, installation of a new element.
2. Checking the temperature sensor. Replacement in case of breakage.
3. Diagnostics of the electronic board.

d04 Control module failure. The triac on the board broke. To remove the error, you need to replace the main module or repair the board.

d07

ER12

The hatch door is not tightly closed. If the code d 07 is on the display, there are problems with closing the door.

1. Check the handle and door lock.
2. Test the electronic lock (UBL) for operability. Replace if necessary.

d10 SMA tank is full of water. In the Fagor washing machine, the pressure switch or control unit is faulty. How can you solve the problem:

1. Replace pressure switch.
2. Check and replace the main unit.

d21 Electronic board error. If the display shows code d 21, the control board is out of order. Installing a new part. F01 There is no set of water in the washing machine tank.

• Low pressure in the water supply.
• Clogged filling system.

1. Turn off the water supply valve to full capacity.
2. Check and clear blockage in inlet valve, inlet hose.

F02 Drain error. No drum rotation.

• The drain pump has failed.
• Blockage in the drain system.

1. Installing a good pump.
2. Cleaning the drain pipe, hose and pump filter.

C03 At C 03 the drum does not work.

• Drive belt defective.
• Motor brush wear.
• Fagor washing machine engine failed.
• Failure of the electronic module.

1. Replacing the drive belt.
2. Replacement of brushes of the electric motor.
3. Checking and reinstalling the motor.
4. Change of control unit.

F04 SM does not turn on.

• There is no mains voltage.
• Faulty control module.

How to repair the damage:

1. Check for mains voltage.
2. Check the extension cable if the CMA is connected through it.
3. Replace control unit.

F05

F06

TENA malfunction. The heating element has failed. Testing and installing a working element. F07 Problems in the pump circuit. The circuit between the module and the pump is broken.

1. Repair of damaged sections of the chain.
2. Replacement of the electronic module.

F08

F09

Washer motor defective. Inspection and replacement of the electric motor. F0 Failure of the electronic module. The module failed due to a short circuit or moisture ingress. Reinstalling the block.