Contents
There are some problems that you can fix yourself. If your washing machine does not drain water well, you need to check the drain system. In the article we will tell you how to unscrew and clean the filter in the Indesit washing machine.
Why filtering is needed
The manufacturer has provided two filters for SMA – drain and filler. Both are designed to protect the machine from foreign objects. The inlet mesh filter traps large particles in tap water. And the drain protects the pump from getting small objects during operation.
Each user manual indicates the mandatory cleaning of the filter of the Indesit washing machine.
Not all users adhere to the rules, so they get malfunctions in the operation of the SM, a decrease in the drain rate, or a complete lack of water pumping.
What does the filter look like and where is it located?
The drain filter is also considered a drain or garbage filter. It is a kind of cork that is screwed into the bottom of the washer. To find out where the filter is located in the Indesit washing machine, look down the case.
In the lower right corner, you will notice a hatch. Behind it is the pump protection.
Self cleaning
Before starting any work on the equipment, always unplug it from the mains. Then turn off the water supply, disconnect the inlet hose, drain the remaining water into the sink or tub.
How to open the drain and filter in the Indesit washing machine:
- Pry off the lid of the small hatch, which is fastened with latches, and put it aside.
- Behind the lid you will see a detail with a notch.
- Place a piece of cloth or a container beforehand, as water may spill out.
- To unscrew the drain (water) filter in the Indesit washing machine, you must firmly grasp its recess.
- Turn the thread and turn counterclockwise.
- When you reach the stop, pull out the cork.
To properly clean the drain filter in the washing machine from clogging, rinse it under running water and clean it with a sponge.
Pay attention to the hole in which he was. Shine a flashlight inside, check that there are no threads wrapped around the pump impeller. If you see debris, remove it.
Possible difficulties
Please note: some manufacturers additionally fasten the part with screws. How to unscrew the cover and pull out the filter from the Indesit washing machine?
Act consistently. Also open the hatch, but before turning the handle, unscrew the bolts.
Self-cleaning should be performed once every 3 months, at least once every six months.
You may also encounter a problem: the filter in the Indesit washing machine does not get out.
This happens when a strong blockage is formed. If the part has not been cleaned for a long time, it could boil. Then you need to get a drain pump.
Sequencing:
- After disconnecting all communications from the machine, lay it on its side.
- If the bottom is covered by a panel, remove the bolts and set it aside.
- Loosen the clamps and remove the pump nozzles.
- Loosen the fastening screws.
- Disconnect all connectors.
- If the filter does not come out of the washing machine, pull out the pump and disconnect the part.
With strong fixation, it is recommended to use WD-40. After you have removed the filter from the Indesit washing machine, proceed to clean it.
By carrying out timely prevention of blockage, you will avoid many problems with the operation of the SM. It is not difficult to do this work yourself, but in the future you will avoid problems and repairs.
Related video to help: