Contents
The correct operation of the washing machine largely depends on how it was installed. It is important to arrange it not only conveniently, but also without slopes and distortions. In this article, we will take a closer look at how to install the washing machine evenly on our own, without calling the wizard. First of all, you need to choose a place where the SM will stand. In order not to be mistaken in the correct location, you should analyze all possible options.
Where to install SMA
There are several recommendations, following which you can find the best place for installation:
- All communications of the washing machine should be located next to each other.
- Install the machine on a perfectly flat floor.
Even by choosing a location, you cannot be sure that the machine will not jump and vibrate. Therefore, you need to proceed to the next step – adjusting the legs. Read on for tips on how to level your washing machine.
How to adjust washing machine feet
Vibrations are a serious problem that can cause irreparable harm: they lead to violations of screws, bolts and other fasteners in the machine. Vibrations also cause frequent breakage of the plastic tank – if it bursts, water will flow. To avoid all these problems, you need to tighten the legs on the washing machine.
Incorrect installation threatens not only the breakdown of the washer, but also damage to surrounding objects. The machine may move out of place due to strong vibrations.
Smooth and correct installation is ensured by special adjusting legs provided by the CMA manufacturers.
To increase or decrease the height, screw the leg into the body or unscrew it from it. These actions will help level the machine without much effort.
You do not need to immediately unscrew the legs as much as possible.
Important points when adjusting the legs
Understanding how to adjust the washing machine, you can twist or unscrew the legs, setting it in a level position. To check the slope of the CMA, you will need to level the washing machine. It can be used to measure deviations.
- Place the tool on top of the washer body.
- Place the level so that it is parallel to the sides of the machine. The bubbles in the flasks must be within its lines. The same applies to the installation of the tool parallel to the side walls.
- Deviation in any direction is evidence that you need to adjust the legs of the washing machine. How to do this – we have already dismantled.
There are tons of videos on the net about how to properly adjust the legs. To accomplish this task, use one of them:
Step by step machine installation
By properly installing and connecting the washer, you will ensure the quiet operation of the washing machine. Following the instructions, everyone will be able to cope with the installation of CM:
- Before installation, it is necessary to remove the rear wall and remove the transport bolts. They securely fix the drum, preventing loosening.
- Choose a location where the surface is flat and hard. This is where the washer is best placed. Soft rubber mats should not be used. If the SMA is installed incorrectly, then at high spin speeds it will make a lot of noise and vibrate, staggering in all directions.
- Then plug the washer into a grounded outlet. In this case, washing will not be accompanied by unpleasant noises and buzzing.
An analysis of how to balance the washing machine guarantees a safe and long service life. The washing machine will work silently, without “running away” anywhere. There is nothing easier than installing a washing machine in the bathroom, kitchen or utility room. Following the recommendations on how to adjust the washing machine is a guarantee that many problems will be avoided in the future.