Contents
How to glue fillets on the ceiling, in corners and on curved walls
Ceiling plinths, or fillets, as they are also called by professionals, is a finishing material that gives a home renovation a complete look. Also, with similar details, you can close the resulting space between the wallpaper and the ceiling. However, not everyone knows how to glue fillets so that they do not fall off the walls afterwards, but hold until the next interior update. It’s easy to do it yourself. Here it is only important to calculate and measure everything correctly. Then everything will definitely work out.
How to apply fillets to the ceiling?
In order for the ceiling plinths to look neat afterwards, you must perform the following steps:
- Apply the adhesive to the fillet area in a continuous strip. Don’t skimp on the solution.
- Now, in turn, coat the ceiling skirting boards with glue. Wait a while for the solution to set a little.
- Bring the fillet to the ceiling and press it into a corner. Then run your hand along the entire length of the strip, and wipe off the excess glue.
- In the same way, glue the perimeter of the room until everything is finally done.
Observe cleanliness during work so as not to stain light fillets. Handle skirting boards with care as they are easily damaged.
How to glue fillets in corners?
Ceiling plinths are glued from the corners. This approach helps to do all the work neatly. Sometimes cornerless fillets are bought, which are then cut off. What is the best way to make a corner?
- Fit the fillet to the ceiling and estimate how much and what you need to trim. You will see how you can create the correct angle.
- Trim the baguettes in the mirror image. For the inner corner, the upper edge of the frieze is made shorter than the lower one, and for the outer corner, the opposite is true.
- Cut the plinth evenly, avoiding the formation of chips and roughness, otherwise the fillet will not adhere well.
Corners are a very important part of the job. The location of the plinth depends on their correctness.
How to glue fillets on curved walls?
In older houses, the walls are uneven. In the future, this can cause the skirting board to separate. To prevent this from happening, glue the fillets, and then treat the cracks with a white sealant. Apply the product to the surface by pressing it inward with your finger soaked in water.
Having mastered this simple technique, then you can enjoy the perfect edging. Repair lovers are interested in the question of when to glue fillets – before or after wallpaper. Here, everyone acts as he pleases, there are no restrictions.