Error F5 in Atlant washing machines – what to do

The Atlant electronically controlled washing machine displays a fault code on the scoreboard. Whereas on washing machines with electromechanical control, the 2nd and 4th indicators will light up.

What does error F5 mean for Atlant washing machines? Problem with water supply. How to fix the situation, consider further.

Finding the cause of the malfunction

If, after starting the program, water is not collected, and the machine shows error F5 on the display, there is a possibility that the filling valve will break. But before disassembling the Atlant washer, you need to exclude other options for malfunctions.

What do we have to do:

  • Check the mesh filter between the inlet hose and the Atlant washing machine. A filter clogged with debris will not allow water to pass through normally, so remove the element and remove the blockage.
  • Turn the water supply valve. With incomplete opening, a small pressure is formed, so the valve must be opened at full capacity.

You tried all the ways, but the F5 error did not reset. How then to troubleshoot? It is necessary to check the valve itself and its coil on SM Atlant.

Diagnostics and repair

Let’s take a look at how the valve works. Usually it is in the closed position, but when voltage is applied to its coil, the valve opens – water is poured. Depending on the model of the Atlant washing machine, the element is installed on one, two or three coils.

In order to remove the F5 error in SMA Atlant, as well as fix the breakdown, check the valve’s performance. What does it mean:

  1. Remove the top cover of the washer by unscrewing the two screws on the back.
  2. The element is located at the top, near the wall.
  3. Open the water supply (do not forget to substitute a container).
  4. Apply 220 volts to each coil.
  5. The service valve will open.

The video will help you:

If you can’t open it, check the resistance of the coil. For this:

  • Connect the multimeter leads to the coil.
  • Measure resistance. Error F5 in Atlant washing machines - what to do
  • The working coil will show 2 to 4 ohms.

You can remove the faulty coil and install a new one.

Plastic inserts

Another common problem is associated with plastic inserts that are located in fittings to control water pressure. If the insert fails or falls out, the pressure will be too high. An F5 error will be displayed on the screen.

In this case, the valve must be completely replaced.

Self replacement

Be Consistent:

  1. Turn off the water supply.
  2. Use pliers to remove the clamps on the valve hoses.
  3. Disconnect the hoses (keep in mind that they may contain water).
  4. Loosen the fastening screws or unfasten the latches.
  5. Install the new part in reverse order.

Now start the Atlant washing machine, check its performance. If everything is in order, and the error does not appear again, then everything is done correctly.

Faulty wiring

Another reason why the Atlant washing machine gives an F5 error may be a wiring fault between the module and the valve. Visually inspect the cable at the time of violations, tighten the connections. In case of minor damage, the wire section can be insulated. You may need to completely replace the cable.

If you did not manage to solve the problem and remove the F5 error yourself, call the wizard.

Leave a Reply