Contents
When the Indesit washing machine issues a fault code F 14, this allows you to independently diagnose and solve the problem. However, first you need to figure out what the F14 error on the display means and why the laundry remains damp after drying.
On Indesit CMA electromechanical models, the “Wash Delay” – “Super Wash” – “Quick Wash” lights may light up. This means that the drying heater is not working.
Causes of the problem
If you notice that the laundry remains damp after washing and drying, this may be the reason why the machine gives error code F14:
- TENA failure.
- The safety thermostat of the electric heater has tripped.
- The heater fan has failed.
- The presence of water in the tank.
There may also be defects in the wiring that connects the control module to the heating element.
The last and unlikely version when error F14 is displayed is a malfunction of the control board. But before considering such an option, it is necessary to exclude other factors.
Help at home
When the Indesit washing machine shows error F14 on the display, you need to know how to fix it.
It is necessary to exclude program failure. To do this, reboot and try to reset the error. If these steps do not help, proceed to the next step.
Heating element malfunction
How do you know that the cause of the breakdown is in the heater? The washing machine washes normally, but the laundry is damp when you take it out. So the dryer didn’t work.
- Obesotch’te SMA Indezit.
- Remove the top panel.
- Unscrew the bracket and remove the door cuff.
- Disconnect the wires and open the heating chamber.
- Loosen the screws securing the heater.
- Remove the heating element and check it with a multimeter in case of an open circuit.
- In the event of a malfunction, install a new heater in reverse order.
The reason is the safety thermostat
Clothes remain damp when the thermostat is activated. Perhaps you overloaded the washer with laundry, as a result, the electric heater overheated and the protection worked. You can solve the problem by dividing the clothes into several parts and drying them one by one.
A faulty heating element fan also leads to its overheating, the appearance of an error code. How to troubleshoot? Replace fan.
You can remove error F14 by checking the air duct for blockage if other methods have not led to anything. What you have to do: disassemble the dryer and eliminate the blockage, and then check the Indesit washing machine for performance.
Poor water drainage
The drain filter could also be clogged. The water does not drain completely, as a result, we take out wet laundry from the Indesit machine. Check filter, clean if necessary. Do not forget about the drain hose, which also does not hurt to rinse.
Video will help:
Recognizing the F14 error, you can easily fix all the problems. If the above methods did not bring results, it is better to contact the service center.