Error F07 in the Ariston washing machine – how to deal

Why does the Ariston washing machine show error F07 on the display? The reason is that the heating element is not covered with water. Learn how to fix the problem and clear the error code yourself.

Electromechanical SMAs indicate a fault code by blinking the lights “Super Wash” – “Quick Wash” – “Extra Rinse”.

Below we will analyze in detail what the error means, and what to do if it occurs.

How to fix the error

If error F 07 is on the display of the Ariston or Hotpoint-Ariston washing machine, try to solve the problem with simple steps:

  • Do not rule out the possibility of a system failure. To reset the F07 error, you need to de-energize the Ariston SM, and then turn it on again after 20 minutes. The error disappeared – the reason was a failure, it appeared again – try other options.

How to fix a broken washing machine Ariston and Hotpoint Ariston

For AVL and AVD washing machines with EVO-II controller:

  1. Check if pressure switch connector J3 is connected to the electronic module. It happens that the wires depart or burn out due to sudden surges in electricity. It may be necessary to solder or replace damaged areas.
  2. Inspect the pressure switch for damage. Faults are found, so the part needs to be replaced.
  3. Check the heating element by measuring with a multimeter. If everything is in order with the heater, at a power of 1800 W it will show a resistance of about 25 ohms. What to do if the heating element did not pass the test? Will have to replace it.
  4. If the cause is the control board controller, it will need repair or a complete replacement.

Washing machines Ariston “Margarita 2000” (AL and ALS) with EVO-I controller:

  1. Inspect the wiring to see if there is a contact in the electrical module connector CM1.
  2. Carry out diagnostics of the heating element relay on the controller.
  3. Replace the electronic module if necessary.

If, nevertheless, the heating element did not pass the test, and the machine gives an error F 07, which indicates its malfunction, we will tell you how to replace the heating element.

How to remove and replace the heater

To remove the error and return the washing machine to normal operation, proceed:

  • If you checked the heating element as indicated in paragraph 3, then all the wires have already been disconnected.
  • Using a wrench, unscrew the fastening nut under No. 1 in the photo.
  • Press firmly on the remaining pin (No. 2), sinking inwards.
  • Since the heater is sealed with rubber, pry it from the edge (in photo No. 3)
  • A working heater is installed in the reverse order.

If everything is correct, the Ariston washing machine will work as before. How to check the heating element correctly, look at the video:

Leave a Reply