The electronic control system greatly facilitated the use of equipment. The set temperature and modes are displayed on the display in the same way as the errors of the Electrolux refrigerator. Any malfunction is displayed on the board in the form of a code, the meaning of which can be found in the instructions. Having learned the decryption, you will quickly find out the cause of the breakdown and how to fix it.
Electrolux error codes: table
A fault code may appear on the display accidentally due to a malfunction in the system. In order not to search for reasons in vain, restart the equipment. Pull the plug out of the socket and connect only after 15 minutes. If the characters are still displayed on the screen, it’s time to start deciphering.
| Error code | Which means | How to fix it yourself |
| F1, F2 | The thermostat is not working. | Run diagnostics on the part. Inspect the wiring: the contacts may have come off. Replace defective items. |
| F3, F4 or F5 | The NTC temperature sensor is defective. | Tighten the contacts from the sensor to the control module. Replace sensor if broken. |
| Blinking “-” on the display | The temperature in the refrigerator compartment is below 0 degrees. | There is a problem with the evaporator. It is possible that the sensor is giving incorrect readings, so the compressor does not stop cooling. For an accurate diagnosis, it is better to consult a specialist. |
| The value “-” is constantly on | The temperature is above the specified norm: more than 9 degrees. | Follow the same steps as for the previous problem. And:
|
| indicator b is lit | The evaporator sensor is out of order, or there is a freon gas leak. | Your actions:
|
| LED with | Temperature sensor malfunction. | Repair, installation of a new element. |
| light bulb d | Thermistor elements have failed. | Installation of correct parts. |
| Indicator o (as half of the number 8) | The freezer evaporator sensor does not work. | Diagnostics and replacement. |
Also, users of Electrolux refrigerators face the following problems:
- Noise during work.
- Condensation, accumulation of water under the drawers.
- Growths of ice and snow on the walls.
- Hot walls during operation.
- Breakdown of electrical components.
Don’t let the drain hole become clogged, don’t keep the chamber door open for too long, and you’ll avoid a lot of damage.