A typical situation – you bought a new washer, but during installation you realized that the drain hose does not reach the sewer. If there is no way to move the machine closer, it does not matter. The best way out is to extend the drain hose for the washing machine. Using the advice of experienced professionals, you will extend the drainage system quickly, easily and without harm to the device.
Necessary materials
Before you go shopping, take the necessary measurements:
- Measure the length of the distance that was not enough to the sewer pipe (siphon) to determine the length of the tube. It is better to buy longer and cut off the excess than not enough. Initially, the SM developers calculate the drain length based on the pump power, so adding extra meters increases the load on the pump. If the distance to the sewerage system is three times higher than the norm, this is fraught with pump breakdowns, stagnation of water in the hose, tank, and the appearance of an unpleasant “swampy” smell in the drum.
- Measure the diameter of the drain hose. It is desirable that the diameter of the additional one coincides with the “native”. If the extension cord is narrow, it can be torn off by pressure and a flood will occur.
Shopping list:
1. Hose extension.
It is great if it is of the same brand with the machine, but this is not necessary. The main thing is the desired length and diameter. The cost depends on the length and quality – from 9 rubles to 200 and more. For example, for 200 rubles you can buy corrugated, sliding and independently adjust the length from 1,5 to 5 meters.
2. Connector.
It is also called a connector or fitting. Experienced locksmiths and plumbers affectionately refer to this spare part as a “brush”. When choosing a part, you will need the previously measured diameter. Since the connector is double-sided, the section of each side must match the hose ends. The cost may vary depending on the size and material, 10-20 rubles on average.
3. Clamps.
You will need two of them – to fix the limit switches on the connector. A reliable option is plumbing or automotive metal clamps. The range allows you to roam – a variety of materials, models, sizes. Therefore, prices vary, but it is quite realistic to buy one ring for 15 rubles.
4. Phillips screwdriver. To tighten the clamps, most likely, you will not have to purchase it, this tool can be found in any home.
How to lengthen the drain hose?
Step-by-step instruction:
1. Put a clamp on the limit switch, then attach it to one side of the fitting.
2. Do the same from the side of the extension.
3. Tighten the clamps.
4. Attach the extension to the sewer pipe or drain siphon.
5. Run the test mode.
See how easy it is? Shopping took more time than the process itself. This trick can also be done from the side of the inlet hose, if the water pipe is far enough away.
important points
When connecting the drainage system, be sure to read the instructions, because the technical features of the model often affect the installation rules.
General recommendations:
- Bend the hose with the Latin letter S and fasten it to the rear wall of the housing.
- Place the outlet at a level of 40 cm from the floor.
- The connection must be on the top side of the pipe, not the bottom, otherwise some water will remain.
- Use sealants to strengthen joints.
- Spare no money on quality parts, it is cheaper to pay once for good quality than to eliminate the consequences of the flood.
As you can see, lengthening is easy to do on your own, without the help of professionals. The main thing is to stock up on everything you need, follow the instructions and safety precautions. An example in the video:
We wish you easy and successful work!