Daewoo washing machine error codes – what to do

Washing machines from Daewoo (Daewoo), just like other modern machines, are equipped with a self-diagnosis function. Therefore, if you notice that the CM is showing an error code on the display, do not worry.

The table below lists all error codes and their meaning. You will know what to do when they appear.

Table of errors and malfunctions of the CMA Daewoo

Error codeWhat it meansCauses of appearanceHow to fix a breakdown
OEThe OE code means problems with draining water.
  1. Incorrect drain hose connection.
  2. Clogged drain tract (pipe, filter, hose, pump).
  3. The pump or its wiring is faulty.
  1. Check the connection and position of the drain hose. It must not be twisted or pinched.
  2. Clean the drain hose, filter, pipe from blockage.
  3. Replace pump, repair wiring.
IEThe water is not pouring well.Why is the IE code on the CM display:
  1. The water tap is closed.
  2. Insufficient water pressure.
  3. Blockage in the intake system (filter, hose, valve).
  4. The inlet valve has failed.
  5. The pressure switch does not work.
How to fix the situation:
  1. Open shut-off valve.
  2. Check and clean the inlet hose, mesh filter, valve.
  3. Replace inlet valve.
  4. Install a new pressure switch in case of malfunction.
UEWhat does the UE code mean? There was an imbalance.The reasons:
  1. Incorrect installation of the Daewoo washing machine.
  2. Incorrect distribution of laundry in the tub.
To reset an error:
  1. Check the correct installation of the SMA. The legs must be stable on the surface.
  2. Open the hatch, manually distribute the laundry in the drum.
LEDoor lock defective. The door is not tightly closed.Why does the washer give an error LE:
  1. The door is not firmly fixed.
  2. The door warped.
  3. Faulty mechanical lock, handle.
  4. The electronic interlock (UBL) is broken.
To solve the problem, do this:
  1. Press the door harder.
  2. Pull up the side loops.
  3. Inspect and replace the latch or door handle.
  4. Install the correct UBL.
E2overflow errorSMA tank fullCheck:
  • Filling valve (opens to fill the machine with water).
  • Pressure switch (water level sensor).
  • Drain pump (pump – pumps water out of the tank).
E6EMG error• The laundry is wedged between the pad and the drum. • Faulty motor. • Faulty control board.• Arrange the laundry differently in the drum. • Repair or replace the engine. • Replace defective board.
E8The loading sensor is defective.The E8 code was displayed because the load sensor failed.What to do? Replace defective element.
E9What does error E9 mean? Problems with the operation of the pressure switch.The reasons:
  1. Leaky fastening of the pressure switch tube, or its blockage.
  2. Pressostat malfunction.
To remove the error, you need:
  1. Check sensor tube connection.
  2. Clean it from blockage under the pressure of water.
  3. Change pressure switch.
H6Failure in the operation of the heating element.The heater circuit has been damaged or broken due to a short circuit.Your actions:
  1. Inspection of the heating element and its circuit.
  2. Installing a new heater.
  3. Chain repair.

Following the recommendations, each user will be able to fix the breakdown with their own hands. Therefore, before contacting a service center, conduct an independent inspection and diagnosis of a breakdown.

Leave a Reply