Beko refrigerator error codes: decoding, repair

Refrigeration equipment “Beko” is equipped with a self-diagnosis system. It allows the user to quickly determine the cause of the failure. How it works? An error code appears on the display of the Beko refrigerator: the data of the temperature indicator is changing. If you notice similar values ​​on the screen, you need to look at the decoding in the instructions or in our table.

Veko refrigerator malfunctions

If the icons appear on the display, reboot the equipment – this may be a system failure. For this:

  • Disconnect the unit from the mains.
  • Wait 10-15 minutes.
  • Reconnect.

If the error appears again, then you need to start diagnosing and repairing. See the table below for the meaning of faults.

Flashing temperature displayCode meaningCauses of appearanceHow to fix the problem
+2There were problems with cooling.
  • The circuit is damaged, freon gas is leaking.
  • The compressor is broken.
  • The fan in the chamber is not working.
  • The thermostat has failed.
  • The door is not tightly closed.
Your actions:
  • Inspection of the circuit, identification of the place of damage. Repair and refueling of the system with refrigerant.
  • Diagnostics and replacement of the motor.
  • Check contacts and fan motor. Replacement of defective parts.
  • Installation of a new temperature controller in the compartment.
  • Replacing the door seal, tightening the fasteners.
+3The heating element has failed.Why did this happen:
  • TEN burnt out.
  • The contacts are open.
  • Broken wiring.
You must check the elements and replace if they are defective.
+4There is no contact with the sensor.The reasons:
  • Sensor contacts are loose.
  • Burnt out wiring.
  • Wrong connection.
What to do:
  • Pull contacts.
  • Check the cable and install new wires in place of the burnt ones.
  • Check connection.
+5The sensor is closed.Why:
  • The contacts between the sensor and the electronic module are broken.
  • The sensor is defective.
Your actions:
  • Connection diagnostics. Repair of defective elements.
  • Replace the part.
+6The key on the control panel has been activated.Stuck or stuck button. Perhaps the element has worn out, or liquid has got on the panel.You need to disassemble the panel and repair or replace the broken key.
+7There are problems with the compressor.What could be the reason:
  • There is a blockage in the system. The refrigerant cannot circulate normally.
  • Circuit damaged. The gas flows out.
  • Compressor motor defective.
How to fix the situation:
  • Determine the location of the blockage and remove its causes. Often the pipes become clogged with burnt oil particles in the motor. Additionally, you need to check the oil. Top up with new if necessary.
  • Eliminate the cause of the leak. Top up the system with freon gas.
  • Run engine diagnostics. Perform repair or replacement.
-12The switch does not work.Poor wire connection between main module and switch.

Your task: checking the wiring, tightening the contacts. Replacement of burnt parts.

There may be other problems where the temperature on the display fluctuates.

  • The compartment door opens frequently.
  • The seal is damaged, which leads to the penetration of warm air into the chamber. You need to clean it if it is clogged or install a new one.
  • Loaded with a lot of warm foods. As a result, the temperature in the chamber rises, which leads to the activation of the sensor. Start the “Supercool” mode, if it is provided in the model. Or wait 20-30 minutes until the climate returns to normal.

Some malfunctions of the Beko refrigerator can be fixed on your own. But there are such breakdowns that require the intervention of an experienced craftsman and the availability of special equipment. If you are not sure that you can handle the problem, contact the service center.

1 Comment

Leave a Reply