Atlant refrigerator errors allow us to understand the cause of the breakdown. If your model is with an electronic control system, you will find fault codes on the display. Their decoding is in the instruction manual and in the table below. Having learned the meaning of the code, you will find the problem and you can fix it yourself.
Atlant refrigerator error codes
What to do if the technique gives an error? First of all, reboot the system: unplug it for 10-15 minutes, then look at the display again. Icons disappeared from the screen? So, the reason is a system failure. If they are highlighted again, then it’s time to study our table.
| Malfunction code | Which means | How to fix the problem |
| F1 | In refrigerators with electronic control, the air sensor does not work. | Check the wiring and tightness of the sensor contacts. Replace part if broken. |
| F2 | No signal from evaporator sensor. | Inspect the wiring harness from the main module to the sensor for damage. Check contacts. Install correct parts. |
| F3 | The sensor in the freezer does not work. | Diagnose and replace broken parts. |
| F4 | Insufficient voltage in the network: below 170 volts. | You need to wait until the voltage is restored. Experts recommend for large equipment install stabilizers. |
| F5 | Increased voltage in the network: above 260 volts. When the voltage is exceeded by 10%, the control board shows an F5 error to protect the refrigerator components from burning. | The problem will not be fixed by the service center wizard. Preventive work in electronic networks, replacement of wiring in the house will help. Also installing a stabilizer. |
| F6 | The two-chamber refrigerator received a malfunction of the refrigeration compartment motor. | If the equipment has completely stopped working, diagnose the electronic module:
You need to repair the defective item. |
| F7 | Freezer compressor failure. | |
| Flashing L | The temperature in the freezer or refrigerator compartment is too low. | Adjust the thermostat readings. |
| Flashing H | The temperature in the chambers has been exceeded. |
The reasons for the appearance of the H error should be discussed separately. Situations that do not require repair:
- Loosely closed compartment door. Push her harder.
- Accidentally turned temperature knob, the value is too high.
- If you have checked the first two points, but H continues to flash, defrost the refrigerator – at least 24 hours.
What else could cause the code:
- The light does not turn off when the door is closed. Then it starts to heat the interior of the chamber. It is necessary to check and replace the switch, clean the contacts.
- Loading a large number of products. Wait about half an hour until they cool down and the microclimate in the department is restored.
It is not recommended to put hot food in the refrigerator. This will lead to the accumulation of condensate and the formation of frost on the walls.
- Deformation, wear, contamination of the seal on the door. You can restore the shape of the seal with hot water: pour the rubber in a thin stream. You can clean it with soapy water. When worn, the element must be replaced.
- Socket broken, plug loose. Check your network connection.
When you can’t do without a specialist:
- Freon gas leak. The system through which the refrigerant circulates is inspected: capillaries, valves, filters. If the capillary tube is in oil, this indicates a refrigerant leak. It is necessary to eliminate the leak and refuel the system with gas.
- Compressor motor problems. If you notice that the compressor works non-stop and does not turn off for rest, carry out diagnostics.
- Clogged capillary line. The system needs to be cleaned.
Do not panic when a code appears on the display. Problems can be fixed by calling the wizard or by making your own efforts.